Flashlight Bulb LED Upgrade - 250+ lumens - CREE R2 Single Mode Drop-in - P60 design: Surefire, Hugsby, Etc.

Flashlight Bulb LED Upgrade - 250+ lumens - CREE R2 Single Mode Drop-in - P60 design: Surefire, Hugsby, Etc. Short Description

DON'T BUY A NEW FLASHLIGHT! UPGRADE THE ONE YOU ALREADY OWN!

INCREASED BRIGHTNESS

Rated at up to 300 lumens, this drop-in will dramatically increase the brightness of any incandescent flashlight and many older LED flashlights. The color temperature for this light is approximately 6,200 K which means it is much closer to true daylight than regular bulbs which provides a more natural light that is easier to use.

INCREASED RUN-TIME

LEDs are much more efficient than a typical incandescent light. Increased efficiency means less unwanted heat, longer run-time and fewer changes of costly batteries. You'll likely make back the purchase price of this LED module in savings on batteries alone.

NEVER BUY A BULB AGAIN

Bulbs from the leading flashlight brands cost + depending on the brightness and the manufacturer. For most incandescent bulbs it is common to be forced to change the bulb about every 4th or 5th battery change which gets extremely costly. With LED technology, you'll never have to worry about replacing a bulb and they remain just as bright on the first use as on all subsequent uses.

COMPATABILITY:

SureFire® : 6P, 9P, C2, D2, G2, G2Z, M2, and Z2

G&P® : T-6, T9, X-6, M3, R12

SpiderFire® : X03, X6V, X9V

SolarForce® : L2

UltraFire® : WF-501A/B/C/D , WF-502A/B/C/D , 6P, 9P, G60, G90

HUGSBY : G2, M2, S3

Others: This should work with most flashlights that this module will fit into. Measure your flashlight to be sure.

NOTE: This module includes two springs, an inner spring which is used to make contact with the batteries and an outer spring which is required on only some flashlights. Many flashlights such as Surefire will require the outer spring to be unscrewed from the module.

SPECS

Dimensions:

Bezel Diameter: 26.5mm (1.04 inches)

Length: ~29mm (1.14 inches)

Modes: Single Mode

Voltage: 3V~8.4V